标题:
power PCB铺铜时遇到的问题,请高人指点迷津~~~
[打印本页]
作者:
tangxm0122
时间:
2005-9-26 23:39
标题:
power PCB铺铜时遇到的问题,请高人指点迷津~~~
THERMAL RELIEF ERRORS REPORT -- 000.pcb -- Mon Sep 26 23:04:31 2005
Drilled pads with Nondrilled pads with
less than 50% thermal extensions less than 50% thermal extensions
Report of Thermal Spokes Generator.
On Top:
(6430, 5350) # = 0
(5750, 5325) # = 0
(7010, 5250) # = 1
(6610, 5180) # = 0
(7360, 5110) # = 1
(7000, 5775) # = 1
(3070, 6550) # = 1
(3070, 6110) # = 1
(4400, 6290) # = 1
(4400, 6260) # = 1
(4400, 6125) # = 0
(4710, 5290) # = 0
(5530, 6600) # = 1
(5280, 6600) # = 0
(5690, 6300) # = 0
(5710, 6250) # = 1
(5710, 6110) # = 1
(5710, 6000) # = 1
(5710, 5860) # = 1
(5710, 5680) # = 1
(4400, 5470) # = 1
(4400, 5510) # = 1
(4400, 5690) # = 0
(4400, 5860) # = 1
(4400, 5900) # = 1
(4400, 6000) # = 0
(3450, 6050) # = 0
(2900, 5500) # = 0
(2750, 5410) # = 0
(3175, 4875) # = 1
Total Drilled pads: 30 Total Nondrilled pads: 0
Report of Violating Thermal Spokes Remover.
On Top:
(7010, 5250) # = 0
(3050, 5030) # = 0
Total Drilled pads: 2 Total Nondrilled pads: 0
请问以上错误问题出在什么地方呀??
作者:
一通百通
时间:
2005-9-27 09:11
你是铺铜后出现的报告,还是先弹出报告而铺不上铜?
作者:
tangxm0122
时间:
2005-9-27 09:15
是铺铜后出现的报告呀
铜能铺上
作者:
Astra
时间:
2010-8-12 11:39
表示那些坐标对应的焊盘没有引出2条或2条以上的导线与铜皮连接,因为你设置的min.spoke值是2,将其改为0就可以了。
欢迎光临 电子技术论坛_中国专业的电子工程师学习交流社区-中电网技术论坛 (http://bbs.eccn.com/)
Powered by Discuz! 7.0.0