电子技术论坛_中国专业的电子工程师学习交流社区-中电网技术论坛

标题: xds510仿真器出错，哪位能帮忙解决下 [打印本页]

作者: reporter 时间: 2013-11-22 13:38 标题: xds510仿真器出错，哪位能帮忙解决下

我用的是xds510仿真器，板子买了一个多月了，之前仿真的时候一直没有出现问题，可以连接仿真，今天就不能连接，报错信息为
rror connecting to the target:
Error 0x80002240/-121
Fatal Error during: Initialization, OCS, Control,
This error was generated by TI's USCIF driver.

SC_ERR_CMD_HANDLE &lt;-121&gt;
A bad controller handle has been given to a function,
either before attempting to open the controller, or after
having opened the controller and ignored its error status.
Valid controller handles are generated when attempts
to open the controller return a clean error status.

Sequence ID: 0
Error Code: -121
Error Class: 0x80002240
I/O Port = 240

Board Name: C5509A XDS510 Emulator
Cpu Name: CPU_1

Abort:&nbsp; &nbsp;&nbsp; &nbsp;&nbsp; &nbsp;&nbsp; &nbsp;&nbsp; &nbsp; Close Code Composer Studio.
Retry:&nbsp; &nbsp;&nbsp; &nbsp;&nbsp; &nbsp;&nbsp; &nbsp;&nbsp; &nbsp; Try to connect to the target again.
Cancel:&nbsp; &nbsp;&nbsp; &nbsp;&nbsp; &nbsp;&nbsp; &nbsp;&nbsp; &nbsp; Remain disconnected from the target
Diagnostic:&nbsp; &nbsp;&nbsp; &nbsp;&nbsp;&nbsp;Run diagnostic utility.
百度了一下，说是仿真驱动有问题，但是设备管理器显示的都已经安装好了，哪位知道的帮忙解答一下，我学的是C5509，这个问题不解决，后面的学习就没法进行了

欢迎光临电子技术论坛_中国专业的电子工程师学习交流社区-中电网技术论坛 (http://bbs.eccn.com/)