[此贴子已经被作者于2007-5-17 9:50:16编辑过]

[此贴子已经被作者于2007-5-21 15:31:56编辑过]

这里有个基于smac发包的PROJECT，达人能否帮忙看下。这样在MC13213开发板上能否实现发包功能。

好像不能上传文件，那就发下我的主程序，劳烦大虾看下。 

void main(void) {tRxPacket rx_packet;  //SMAC structure for RX packets
 tTxPacket tx_packet; //SMAC structure for TX packets

 byte rx_data_buffer[20]; //Data buffer to hold RX data, if you want larger packets change 20 to what you need.
 byte tx_data_buffer[20]; //Data buffer to hold TX data, if you want larger packets change 20 to what you need.

 UINT16 packet_count;
 
      //Initialize the packet.
  tx_packet.u8DataLength = 0;   //Set TX default to 0
  tx_packet.pu8Data = &tx_data_buffer[0]; //Load the address of our txbuffer into tx structure.

  rx_packet.u8DataLength = 0;   //Set RX default to 0
  rx_packet.pu8Data = &rx_data_buffer[0]; //Load the address of our rxbuffer into rx structure
  rx_packet.u8MaxDataLength = 100;  //Define the max buffer we are interested in.
  rx_packet.u8Status = 0;   //initialize the status packet to 0.
 

   MCUInit();  //Initialize the mcu, setup GPIOs, SPI, clock scheme, etc.
   RadioInit();
   app_init();
    
  MLMESetMC13192ClockRate(0);   /* Set initial Clk speed from MC13192s CLKO*/
  UseExternalClock();  /* switch clock sources to EXTERNAL clock */
 
     /* include your start up code here */ 
   EnableInterrupts;   /* Turn on system interrupts */
  MLMESetChannelRequest(0);   //Set channel zero, can be changed to users preference 
   MLMEMC13192PAOutputAdjust(NOMINAL_POWER); //Set Nominal power setting 
 
 
  app_status = INITIAL_STATE;  //Set the initial app_status of the application state variable to INITIAL_STATE
  
                            //Loop forever
 for (;;) {

  switch (app_status) {
   case INITIAL_STATE:   //For TX    
    app_status = IDLE_STATE; //Switch app status to TX_STATE
    for (i=0; i<18; i++) {
       tx_data_buffer = i;
    }
    tx_packet.u8DataLength = 18; //Set the data length of the packet.  in this case, 6.
    packet_count=0;
    break;
    
        
   case TX_STATE:       //Load the tx buffer with the ZigBee packet.
    if (MCPSDataRequest(&tx_packet) == SUCCESS) //TX Packet, Blocking will stay here until the packet is in the air
    LED1 ^=1;            //MLME_RX_enable_request