executing ASM_layout.hwl

!OPEN source 0 0 60 42
NO CONNECTION
!Source < attributes MARKS off
!OPEN assembly 60 0 40 30
!Assembly < attributes ADR on,CODE off,ABSADR on,SYMB off,TOPPC 0xF800
!OPEN procedure 60 60 40 17
!Procedure < attributes VALUES on,TYPES off
!OPEN register 60 30 40 30
!Register < attributes FORMAT AUTO,COMPLEMENT None
!OPEN memory 60 77 40 23
!Memory < attributes FORMAT hex,COMPLEMENT None,WORD 1,ASC on,ADR on,ADDRESS 0x80
!OPEN data 0 42 60 28
!Data < attributes SCOPE global,COMPLEMENT None,FORMAT Symb,MODE automatic,UPDATERATE 10,NAMEWIDTH 16
!OPEN command 0 70 60 30
!Command < attributes CACHESIZE 1000
!bckcolor 50331647
!font 'Courier New' 9 BLACK
!AUTOSIZE on
!ACTIVATE Assembly Memory Register Command Data Source Procedure
done ASM_layout.hwl

Loading Target ...
Windows NT detected.
USB HCS08/HCS12 MULTILINK detected - Flash Version 5.55
Frequency change to ~4016640hz.
USB HCS08/HCS12 MULTILINK detected - Flash Version 5.55
Frequency change to ~4604288hz.
Device is 9S08QG8.
Mode is In-Circuit Debug.

IO registers loaded for MC9S08QG8 from C:\Program Files\Freescale\CodeWarrior for HC08 V5.1\prog\REG\MCU1019.REG
executing .\cmd\BDM_P&E_Multilink_CyclonePro_startup.cmd

!// At startup the commands written below will be executed
Target Ready
done .\cmd\BDM_P&E_Multilink_CyclonePro_startup.cmd

Startup command file correctly executed.
executing .\cmd\BDM_P&E_Multilink_CyclonePro_preload.cmd

!// Before load the commands written below will be executed
done .\cmd\BDM_P&E_Multilink_CyclonePro_preload.cmd

Preload command file correctly executed.

Loading 1825 bytes.
executing F:\Code_QG8\Project code\MLC_XOSC\bin\Project.xpr

!Data < ADDXPR ONLY_ADD_IF_NEW "main.dbg::S_Que[5]"
MCU Device Selection has been changed.
!Data < ADDXPR ONLY_ADD_IF_NEW "main.dbg::BState"
!Data < ADDXPR ONLY_ADD_IF_NEW "main.dbg:3"
done F:\Code_QG8\Project code\MLC_XOSC\bin\Project.xpr

executing .\cmd\BDM_P&E_Multilink_CyclonePro_postload.cmd

!// After load the commands written below will be executed
done .\cmd\BDM_P&E_Multilink_CyclonePro_postload.cmd

Postload command file correctly executed.

in>

----这是怎么回事？!Data < ADDXPR ONLY_ADD_IF_NEW "main.dbg::S_Que[5]"
MCU Device Selection has been changed.
!Data < ADDXPR ONLY_ADD_IF_NEW "main.dbg::BState"
!Data < ADDXPR ONLY_ADD_IF_NEW "main.dbg:3"
什么意思？

是Command窗口的下载信息

想问一下下载过程中出什么问题了？

什么路径？

在code warriar中直接选debug下载的，要在哪设置路径啊？