首页 | 新闻 | 新品 | 文库 | 方案 | 视频 | 下载 | 商城 | 开发板 | 数据中心 | 座谈新版 | 培训 | 工具 | 博客 | 论坛 | 百科 | GEC | 活动 | 主题月 | 电子展
返回列表 回复 发帖

[求助]:使用MC9S08QG8 Badge Board遇到的问题

我也遇到了,确实不好用,你参考下富昌提供的资料《FMBB_user_manual.pdf》,
9. Forcing the FMBB into BDM Mode:
􀂃 With the USB cable connected to the FMBB, move the 3.3V_SEL shunt from position 1-2 to position 2-3, as in Figure 6.3.1.1-9.
􀂃 Install a shunt at BDC_CON pins 1-2, as in Figure 6.3.1.1-9.
􀂃 After approximately 5 seconds, move the 3.3V_SEL shunt to position 1-2.
􀂃 Remove the shunt from BDC_CON pins 1-2.
􀂃 The MC9S08QG8 is awaiting the execution of the ‘SET GDI’ command.
////////////////
在富昌的评估板上,百试白灵,其他的板子上有时候不行。
还有个hcs08unsecure.cmd 不知道怎么用?请指教。
天剑
you can download the update pack here.
https://www.freescale.com/lgfiles/updates/CWHC08/HC08V5_1_OSBDM_SP.exe
after installing it,you must reinstall your OSBDM driver for windows.otherwise the OSBDM will be wrong,when you use it again.
天剑
返回列表