帮忙看看哪里有错 帮忙

leonquick

编译出错。帮忙看看什么地方错了。我用的是CodeWarrior 4.2.6。

Error   : Identifier expected
DSP56800_zeroBSS.asm line 49    SUBROUTINE "F__bssClear",F__bssClear,F__bssClearEND-F__bssClear

下面是程序，是软件自己生成的代码：

    DEFINE  useSoftwareLoop   ''  

 section startup

; these variables are defined in the linker command file (LCF)

    XREF F_bss_size
    XREF F_bss_addr

 org p:

 GLOBAL F__bssClear

 SUBROUTINE "F__bssClear",F__bssClear,F__bssClearEND-F__bssClear

F__bssClear:

 
; if useSoftwareLoop is defined, assemble this code

    IF  @DEF('useSoftwareLoop')

; clear bss with software loop 

    move    #F_bss_size,y0          ; set count   
 tstw    y0                      ; test count
    beq     end_bssClear            ; if zero count, then exit
  
 move    #0,x0                   ; set x0 to zero
    move    #F_bss_addr,r1          ; set dest address
    nop                            
     
loop_bssClear:     
    move    x0,xr1)+              ; stash x0 value at address r1
                                    ; and increment r1
    decw    y0                      ; decrement count and test
    bne     loop_bssClear           ; if not zero, continue loop     
end_bssClear:

 

    ELSE    ; assemble the following code

; clear bss with hardware loop 
   
    move    #0,x0                  ; set x0 to zero
    move    #F_bss_size,r2         ; set bss size
    move    #F_bss_addr,r1         ; dest address -- bss data start
    do      r2,end_bss_clear       ; do for r2 times
    move    x0,xr1)+             ; stash zero at address
    nop
end_bss_clear:

    ENDIF
   
 rts

F__bssClearEND:

 endsec
 end

zhz2112

将红色部分删除掉就可以了，这一部分对于汇编没用